electrical
Porsche 993 Keeps Running After Ignition Off: Diagnosis Guide
Overview
When a Porsche 993 engine continues to run after the ignition switch is turned to the off position, it indicates a failure in the electrical circuit that maintains power to the Motronic DME relay or the ignition coil. This condition, often called 'run-on' or 'dieseling' in older carbureted cars, is strictly an electrical issue in the 993 fuel-injected system.
Technical Details
The 993 ignition system relies on a specific sequence where the ignition switch cuts terminal 15 (switched power) to the DME relay. If the engine stays running, a feedback loop is likely back-feeding voltage into the circuit. Common culprits include a failing ignition switch electrical contact block, a shorted DME relay, or an aftermarket component back-feeding power into the ignition circuit through the grounding point or shared fuse lines.
Tools & Parts
- Digital Multimeter (DMM)
- Replacement 993 DME Relay (993-615-227-00)
- Ignition Switch Electrical Contact Block
- Trim removal tools for dash access
Common Issues
- Faulty DME relay with internally welded contacts
- Worn ignition switch internal contact plate
- Corroded ground points causing electrical feedback
- Improperly wired aftermarket stereos or immobilizers
- Faulty alternator charge light diode (back-feeding ignition)
Steps
- Immediately pull the DME relay located in the front luggage compartment fuse box to force engine shut down.
- Test the DME relay for continuity; replace if contacts are stuck closed.
- Inspect the ignition switch electrical block behind the key cylinder for signs of melting or physical wear.
- Check the alternator D+ circuit; if the warning light diode fails, it can feed voltage back to the ignition system.
- Disconnect any aftermarket electronic devices (radios, alarms) to verify if they are introducing stray current into the switched 12V lines.
FAQ
Frequently Asked Questions.
Is it safe to drive my 993 if it doesn't turn off?+
No. A car that doesn't turn off indicates a serious electrical fault that could lead to a short circuit, fire, or being unable to stop the engine in an emergency.
Can a faulty battery cause the engine to keep running?+
A weak or faulty battery typically does not cause this. This issue is almost exclusively related to a failure in the ignition circuit or relay management.
Why is the DME relay the first thing to check?+
The DME relay controls the fuel pump and the engine management computer. If the internal contacts are stuck, the ECU continues to receive power and fuel pressure remains active, keeping the engine running regardless of the ignition switch position.
Need This Done Right?
Bring your Porsche to Blamm Motorwerks in Laguna Beach — independent Porsche specialists with factory-grade tooling and real expertise.
